Bouncing snow off the hoophouse from inside, using a broom. Photo Dripping Springs Garden.

For some hoophouse owners, this will be your first winter. Some others will be remembering last winter, and hoping to find a better way of dealing with snow. Snow can be heavy stuff, so removing it is worthwhile. This can be done from the outside, pulling the snow down to ground level, and from the inside, bouncing the snow off the plastic. It isn’t necessary to remove all the snow. Once you have removed what you can, the daytime temperature inside the hoophouse will rise and help melt the rest of the snow. We have never needed to get out of bed in the night to tackle snow, but you might.

First we tackle the outside, or if snow is still falling or it’s frozen onto the plastic, we start with the inside. Either way, start with the south side, to get as much advantage from solar gain as possible. The important rule of snow removal is “First, do no harm.” Don’t make holes in the plastic in your efforts to remove snow! A hoophouse is most stable when the snow is evenly distributed. Since houses are stronger at the ends where they have end walls for support, it makes sense to start at the weaker middle and work in both directions if removing heavy snow.

Snow scraper mounted on a telescopic painter’s pole. Photo by Pam Dawling

For outside we use a tool (SnoBru?m™) which is sold for scraping snow off cars. It’s a foam board about 6″ × 18″ (15 × 45 cm) with a threaded insert that takes a telescoping pole. It is sold with a short pole, but a painter’s pole will give a much longer reach. If you haven’t yet got one of these handy tools, carefully use the back of a rake (wrapped in thick cloth). Pull the snow down between the bows, avoiding pulling the tool over the framework as much as possible, as that can easily make holes. Alternate with shoveling the snow away from the base of the hoophouse if the snow is deep (piles of snow pressing against the lower walls can do damage). Be careful not to hit the plastic with any metal tools. Don’t attempt to use the relatively fragile foam-board tool for pushing snow along the ground; keep it free of grit and use it only on the plastic.

Repurposed car snow scraper. Photo by Pam Dawling.

Inside, don a visor (to keep blobs of icy water from landing on your face) and grab an old broom with its head covered in a cloth or bubble plastic, taped on. Make sure there are no sharp protrusions from the broom head. First walk along the paths nearest the walls banging the broom against the plastic – use the bristle end. We find a double bouncing action works best, and we can get in a rhythm. This can be a long and tiring job! Start at waist height because if the lower snow falls down, sometimes the higher stuff will follow it down, saving you work. When you need to reach higher, tie or tape the broom to a longer stick. Or find something that screws onto your painter’s pole, such as a paint roller (!) and cover that with bubble plastic. Balance applying your energy with being gentle with the plastic. Do not use the foam-board scraper for bouncing snow — it will crack.

When you’re tired and no more snow is easy to move, wait and try again later. The warming effect of incoming daylight will help melt the snow next to the plastic, so that it is easier to start it sliding off next time you do the rounds.

Sometimes ice accumulates on the plastic. If you get freezing rain that sticks on the plastic, it creates a rough surface that keeps any snow that settles on top from sliding off until the ice thaws. The best way to remove ice is to melt it using warmth from inside. If you have double plastic and it is not windy, shut off the inflation blower — the heat from inside will reach the ice sooner. Be very careful if you try to break the ice free mechanically, as there is a big risk of the sharp edges of the ice cutting the plastic. You also risk abrasion every time you use a device on the outside of the plastic to pull snow or ice off the tunnel. This makes the plastic rough, and snow won’t slide off as well in the future.

Snow comes in various consistencies and weights. A foot (30 cm) of light fluffy snow may only contain as much water as 1″ (2.5 cm) of rain. But heavy wet snow can equal 1″ (2.5 cm) of rain in only 3″–4″ (8–10 cm) of snow. Each inch (2.5 cm) of rainwater-equivalent will load a structure with 5.2 lbs/ft2 (25 kg/m2). This is about 6.5 tons (5.9 metric tons) on a 25′ × 96′ (7.6 × 29.2 m) hoophouse! Uneven snow loads make a frame more likely to collapse because there are points of higher pressure. This happens if snow is thicker on one side of the hoophouse or if adjacent hoophouses are too close and snow piles up between them when it slides off the roof. The weight of snow can buckle the side of the frame.

When heavy snow is predicted, turn a heater on a couple hours before the storm begins, with the thermostat at 70°F (21°C) or higher. The cost of the fuel is less than a new hoophouse. A portable propane heater (non-electric!) is a good thing to have on hand for unheated tunnels or if a furnace fails. If you have a very heavy snowfall and it is not possible to remove the snow, then cut the plastic and let the snow fall into the hoophouse to relieve the pressure and save the frame.

We have an “If this, do that” card at the front of our hoophouse log book, to help with decisions. It divides snow events into three types:

• If the night temperature will be higher than 25°F (−4°C) and you expect less than 6″ (15 cm) of wet snow, leave the inflation on, go to bed and hope the snow will slide off.

• If the night temperature will be lower than 25°F (−4°C), or there will be more than 6″ (15 cm) of snow and no wind, turn off the inflation until the morning, letting the interior heat do its best to melt the snow.

• If there is hard sleet or freezing rain, cycle the inflation off for three hours, on for three hours, with the goal of letting the interior heat melt some of the accumulation, and then using the inflation to push the slush off (give it some help in the morning). Repeat this cycle as needed.

Two great resources are Vern Grubinger, University of Vermont Extension, Prevent Greenhouse Collapse and the Rimol Greenhouses Blog How to Reduce Storm Damage to Your Greenhouse and High Tunnel.

Pam Dawlinghas worked at Twin Oaks Community in central Virginia for more than 27 years, growing vegetables for 100 people on 3.5 acres and training many members in sustainable vegetable production. She is the author ofSustainable Market FarmingandThe Year-Round Hoophouse. Pam often presents workshops at MOTHER EARTH NEWS FAIRs and at sustainable agriculture conferences. She is a contributing editor with Growing for Market magazine, and a weekly blogger onSustainableMarketFarming.com. Read all of Pam’s MOTHER EARTH NEWS postshere.

All MOTHER EARTH NEWS community bloggers have agreed to follow our Blogging Guidelines, and they are responsible for the accuracy of their posts. To learn more about the author of this post, click on their byline link at the top of the page.

Your fall garden gave you an abundance of storage squash and now you’re wondering how to use them.

A beginning homesteader learns that comfort and well-being should replace ambition. Instead of beating yourself up over homestead plans that never materialize, vow to celebrate works for your startup farm endeavor.

How you handle the wool during shearing, cleaning, combing and afterwards has a big impact on the quality and value of the wool.

At MOTHER EARTH NEWS for 50 years and counting, we are dedicated to conserving our planet's natural resources while helping you conserve your financial resources. You'll find tips for slashing heating bills, growing fresh, natural produce at home, and more. That's why we want you to save money and trees by subscribing through our earth-friendly automatic renewal savings plan. By paying with a credit card, you save an additional $5 and get 6 issues of MOTHER EARTH NEWS for only $12.95 (USA only).

You may also use the Bill Me option and pay $17.95 for 6 issues.

Canadian Subscribers - Click Here

International Subscribers - Click Here

Canadian subscriptions: 1 year (includes postage & GST)

Copyright 2021, All Rights Reserved | Ogden Publications, Inc.